Tecno IN3 quick specs & features
Tecno IN3 runs on Android 7.0 Nougat themed with HiOS.
This device is a 5.6-inch ips touchscreen display with a resolution of 720 X 1440 pixels, 285ppi. A size of 151 x 72.6 x 7.5 mm and weighs about 212g.
This device is a 5.6-inch ips touchscreen display with a resolution of 720 X 1440 pixels, 285ppi. A size of 151 x 72.6 x 7.5 mm and weighs about 212g.
Powered by 1.3GHz quadcore MediaTek MT6737 processor with Mali-T720MP2 and 2GB of RAM. There’s also 16GB of internal storage which can be expanded up to 128GB with microSD.
There is a 13MP primary camera with LED Flash and a 8-megapixel front selfie camera.
This is a dual SIM Phone with other connectivity options like Wi-Fi, GPS and Bluetooth 4.0. Supports GSM, WCDMA and 4G LTE networks. Sensors on this phone include fingerprint scanner, Compass Magnetometer, Ambient light sensor, Accelerometer, Proximity sensor and Gyroscope.
This device is powered with a 3050Mah non-removable battery
DOWNLOAD TECNO IN3 STOCK ROM
IN3-H3721D-N-IN-180131V88
How to flash this device using Tecno Flash Tool
Note
Follow the instructions on how to flash the device carefully below
I will not take responsibility on whatever may happen to your device.
Flash at your own risk..
Make sure you are downloading the exact ROM of the device you want to flash because
flashing a wrong preloader, will make the device completely dead
(can't power on, can't charge and will not be detected by a computer)
Launch SWD_AfterSales inside the extracted folder
Click on settings icon
Click on load button
Click on load button
Select the scatter file inside the stock ROM folder of the device you want to flash
Select either Firmware Upgrade or Format + Download from drop down menu
Click Confirm Button
Now turn off and connect your device to PC
Wait for flashing process to complete
Reboot device
NOTE
If the while loading the scatter file you see checksum error, copy and checksumgen.exe into the firmware folder.
If there was no cache or userdata inside the ROM folder, you might need to factory reset device from recovery after flash
Select either Firmware Upgrade or Format + Download from drop down menu
Click Confirm Button
Now turn off and connect your device to PC
Wait for flashing process to complete
Reboot device
NOTE
If the while loading the scatter file you see checksum error, copy and checksumgen.exe into the firmware folder.
If there was no cache or userdata inside the ROM folder, you might need to factory reset device from recovery after flash
You can also use other tools like Miracle Box, Volcano, Infinity CMII, NCK etc to flash this device
Report if you cannot download any of these files.
Like and share
Donate to support this site
No comments:
Post a Comment